Something went wrong while trying to load the full version of this site. Try hard-refreshing this page to fix the error.
Hotends & Extruders
Setting unique esteps for multiple extruders
Ender 3 Pro Direct Drive conversion using pancake stepper motor
Creality CR10S hotend temp drop down
Tough All Metal Hot End with CR-10s won't stay tightened
Ender 3 with Titan Aero offset issue
Print starts in a replace filament loop
Top layer problems
Drive Bracket for Tough Extruder Direct to Fit CR10
Can't stop my printer from stringing..
Thermal Runaway Before & After Replacing Parts
having issues with my tough extruder
Extruder gear “clicking”
Can we add a fuse for the thermistor / heater cartridge?
firmware (U1.R2.A8) Réglage Step Extrudeur
Extruder not running
Bondtech DDS issue loading/extruding filament during EZABL install.
TH3D Tough hotend with Sovol SV01 stock extruder
firmware alteration for Gulfcoast Robotics thermistor
Tough Extruder Bearings
Hotend-fan on MKS board doesn't work when TH3D firmware is used
Next Page »
This Forum is run by
TH3D Studio LLC
Terms of Service