Something went wrong while trying to load the full version of this site. Try hard-refreshing this page to fix the error.
Z starting too high
Adding an Extruder For CR-10 to Cura 4.6.1
Fans don't run
Bed and nozzle temperature set themselves to 0 before the end of the print
EZABL Startup Gcode
Cura not outputting temperature setting for print nozzle.
Fine tuning my stock ender 3 with cura 4.2.1
CURA 4.2.1 with ENDER 3 Pro and EZBoard issues(?)
This Forum is run by
TH3D Studio LLC
Terms of Service