To kick off these forums lets get some ideas for what you would like to see us do a giveaway on! Comment below!
EzAbl Pro would be great! Magnetic plate plus the Th3d tough surface is another good one.
Tough RGB Light Kit
EZOUT would be a nice starter.
My vote is for EZABL or Tough Extruder.
I vote we give away an alpha.....
Aaron you buying?
EZABL Pro, Tough RGB Light kit, Nozzles (Always good to have nozzles laying around)
you should give away that m3d rig you never unboxed. You might be hard pressed to even give it away though
Still hasn't printed a damn thing... $700 paperweight
Tim So... it's 'Factory New' then, right?
An RGB kit would be sweet.
I say ezabl it'd be a good reason to get another printer. 😛
EZABL Pro would be a good start.
Ezout or a flexiplate build surface
Big bag of nerds 🙂
JamesKuhlman took out of the box. SD card was defective so the board would not boot. Put in a new card go tit to boot. Then had it heat to 230C/60C for 30 mins to make sure it was working, POP PSU an heroed.