Platform: Ender 3
Firmware: TH3D unified latest stable
EZABL Direct Connect
I've gone through the manual, and I've followed the installation instructions closely. The printer will home all axes with a G28, and I set the Z Offset using the instructions. When I set the Z offset, the position of the Z axis properly homes at 5+the offset when I do G28.
...But when I start printing, after the bed level process, the nozzle either grinds down into the bed or is 4-5mm too high. Eventually I can dial the Z Babystepping in to get it to lay down a good first layer, but it seems like the variance is so wild, it defeats the purpose of bed leveling.
Can I get some tips here? What am I doing wrong?