neslekkim nothing on the hotend, waiting for the hemera. I did do the hack to put the tube in the hotend with the spacer to stop the other tube from popping out, also bought the 50w heater from here. Also waiting for the mag bed - on the wait list for that.
I actually have both of the ezabl sizes - small and big. I found the big one is a bit more easier to install and adjust, and I like that it has a green light indicating that it's on, (red when reacting to the bed), the smaller one doesn't have that green light. I initially went with the smaller one (saving weight on the hotend), but I haven't seen any real difference in the print quality between the two.
I also have one directly connected one to the psu, and the other is connected to a wall wart - and I discovered if you forget to have that wall wart plugged in and powered on, the nozzle will crash 😆 . (happened with the big one - didn't notice the green light wasn't on). So I am making psu box to connect to the pi for control.
My AC bed is coming from Keenovo real soon now (tm) - but with the covid raising hell, may have a wait for that.
I have another aluminum plate I'm making, and the silicon foam (5mm) to sandwich it like they suggest. Hope to drill that out this weekend. Will be running that with a TH3d SCR. then I will convert my mosfet for the hotend.
I still can't get over how quiet the printers are now with the TH3d board - as I mentioned, those fans are on my list to get fix - they make too much noise now.
Future plans include making a complete enclosure for it, with a recycle air cleaner system (wife doesnt want to smell it), led lighting system with Arduino control for system status, and perhaps a linear rail system, that last one because I noticed when I move the y axis, the wheels feel they are dropping into ruts along the 2020, but I can't feel anything when I look for them.