Hi, i have been trying to get my 3D touch probe to work by following this guide:
And wiring the signal to the MOSI pin on the ICSP header.
When i start the printer the 3D touch preforms the self test probing 2 times and then stops with red and blue light on.
Nothing happens when i try to send M280 commands, or using the commands in the menu.
I have done the define custom_probe, bltouch and servo0_pin 5.
Is there anything in the firmware that is stopping me from using the ICSP pins for my 3D touch?
When i tried to set the Z_MIN_PROBE_PIN 7 it stayed as TRIGGERD all the time so i moved it back to the normal one.