Hi I flashed the newest firmware to my Tevo Tornado and have all setting good as far as esteps and EZABL probe setup to meet in the middle of the bed with homing the hotend. When I did a Bed level test it probes a little off in the beginning in the front of the bed. How do I get it closer to where its not off the edge. My offset for EZABL probe edge is 20 as recommended for the mount I'm using. The Home offset adjustment is X -10 Y -10 or is this what i would adjust to center it to the plate more?
If your probe offsets are correct then the sensor should be in the center (not the nozzle) when homing Z.
Home XY and see where the nozzle is to determine if you should use the home offset adjustments or not.
I noticed that with MKS Gen L board Home XY setting do not work from Configuration.h -file. Same thing with X & Y stepper value.
Make sure you are on the latest. There was a bug that was patched (last week I believe) that fixed the home offset settings that was related to MKS printers.