Just placed an order for the New E3D Hemera HE / extruder to upgrade my AM8.
E3d has the marlin 2.0 instructions(link pasted below), but I was wanting to verify/translate to the TH3D firmware settings.
1) TEMP_SENSOR_0 5 for the Hemera (direct drive package) save as V6. Im assuming I can just select #define V6_HOTEND to
2) Hemera uses 409 steps
#define CUSTOM_ESTEPS_VALUE 409
#define TITAN_EXTRUDER_STEPS 409 (if extruder runs backwards)
3) Not sure how to change this...
Marlin has a -15° restriction on the maximum temperature able to be set on the LCD, so in order to hot tighten at 285°C you will need to set the max temperature to 300°C.
4) Create ezabl mount and set offsets for mount below.
#define X_PROBE_OFFSET_FROM_EXTRUDER 10 // X offset: -left +right [of the nozzle]
#define Y_PROBE_OFFSET_FROM_EXTRUDER 10 // Y offset: -front +behind [the nozzle]