Finally finished all my voron prints this morning so got cracking on some assembly. Apparently my math was off because I used all my gt2 belt on the z drives so can’t belt the xy yet. Tucking an ezabl mini in the tool head instead of the Ali special inductive probe the BOM lists. It shows up tomorrow so I can get the tool head put on. Ordered the acrylic for the enclosure today so it should show up in a week or so. That gives me enough time to get the xy belted and all the electronics thrown in and wired up. Spec wise it’s 450x450x450 1200w mains heated bed mosquito hotend mini ezabl morbius 3 extruder with tough tube running dual ramps with a orange pi 3 (if I can get it working, it shows up Monday otherwise it’s getting a pi3b+) running klipper. It’s been a fun build but I’m ready to see if it’s going to print or be a huge failure lol.
HAL9000 NICE! Your going to have to keep us updated about progress and how you like it. I am considering a building a Railcore II.