When I removed my original Creality board I marked just about everything and how it goes back together, I even took pics of the wires. However, I failed to mark how these 2 yellow wires go back onto my new EZBoard. These wires go to the hot end but first these wires run to the back of the CR10’s control box and they end up being pins 1 and 2 on the 8 pin connector on the back of the control box. They then run up to the hot end.
I need to know how they hook to this green connector on my ez board. The pic is BEFORE they were unhooked. Is there any polarity involved ? Is one yellow wire different from its sister yellow wire ? Since they’re identical I would think I could just hook them up to the two connections on the ezboard they go to but I’m afraid there’s something different about the 2 wires and one yellow wire goes in the first hole and the second yellow wire goes in the second hole.
i hope I’m clear on what I need help with.