After installing the EZBOARD on my cr10s during a print the FR slowly increases by itself? Any ideas?
What printer is this on? If you have the menu up does the LCD selection move on its own?
Tim Cr10s. It did at first then I put that board that is included and the random encoder clicks stopped but now the FR increases.
Cr10s. It did at first then I put that board that is included and the random encoder clicks stopped but now the FR increases.
If you are getting encoder clicks and feedrate changes then you are getting EMI issues with the LCD cables. Is that the dual LCD cable or the single? The adapter board was only designed for the single LCD version.
Tim it's two cable lcd.
Then don't use the pullup board. It's only for the Ender 5/3 machines. It can damage your board if used with the dual LCD adapter. You should find the source of the interference that's causing the issues. Usually bad grounding. There are articles in our knowledgebase about grounding on the machines.