Just installed the new Touch Extruder kit on my E3 printer
set the Titan Extruder option to default in Config.h file and updated the Firmware config.
Heat head to 195C for PLA and start the Extruder only getting a small amount of Filament. Checked for Clogs and such.
When I try to print it is only printing small blobs and draging them around the bed. the Extruder Gear is turning very slow as if it is still set like when it was original without the 3:! gearing.
These are the Config.h settings.
Not sure what I am doing worng.
// EXTRUDER SETTINGS -------------------------------
// If you want to change the Esteps for your printer you can uncomment the below line and set CUSTOM_ESTEPS_VALUE to what you want - USE WHOLE NUMBERS ONLY
#define CUSTOM_ESTEPS_VALUE 999
// If you are using an E3D or TH3D Titan Extruder uncomment the below line to setup the firmware to the correct steps and direction
#define TITAN_EXTRUDER_STEPS 463
any help would be great